POS SOLUTIONS

From The Base

1. Power off the unit by unplugging the power cord from the back (for PoE, disconnect the network cable).
2. Wait for 15 seconds.
3. With the unit unplugged, press and hold the connect button on the base station.
   
4. While still holding the connect button, plug the power (or network cable if PoE) back into the unit.
5. Wait until all three lights on the unit are showing as solid green, and release the connect button.
6. Wait approximately 5 minutes.
7. Reboot the unit by unplugging it from power for 15 seconds and plugging it back in.

From The Web Interface

To access the W60B's web interface, we will need it's IP address. The IP address can be found using a connected handset.

1. Press the OK button in the middle of the phone to access it's main menu.
   
2. Navigate to Status Base and the IP address should be listed at the top under "IPv4".
   
3. Enter the W60B's IP address in a web browser as the URL and press the Enter key.
   
4. On the login screen, enter the username (default is "admin") and the password (default is "admin") and click Login.
   
5. Click on the Settings tab, then on Upgrade in the left menu, and finally Reset to Factory.
   
6. Confirm that you want to reset the W60B to factory settings.